ABB ACQ580-31 Schnellinstallationsanleitung Seite 128

128
...G (R6)...
0.5...0.6 N·m (0.4 lbf·ft)
9
...G (R8)...
0.5...0.6 N·m (0.4 lbf·ft)
9
7
7
7
...G
X1 Reference voltage and analog inputs and outputs
1 SCR Signal cable shield (screen)
2 AI1 Output frequency/speed reference: 0...10 V
1...10 kohm
3 AGND Analog input circuit common
4 +10V Reference voltage 10 V DC
5 AI2 Actual feedback: 0...10 V
6 AGND Analog input circuit common
max. 7 AO1 Output frequency: 0...10 V
500 ohm
8 AO2 Output current: 0...20 mA
9 AGND Analog output circuit common
X2 & X3 Aux. voltage output and programmable digital inputs
10 +24V Aux. voltage output +24 V DC, max. 250 mA
11 DGND Aux. voltage output common
12 DCOM Digital input common for all
13 DI1 Stop (0) / Start (1)
14 DI2 Not configured
15 DI3 Constant frequency/speed selection
16 DI4 Not configured
17 DI5 Not configured
18 DI6 Not configured
X6, X7, X8 Relay outputs
19 RO1C
20 RO1A
21 RO1B
22 RO2C
23 RO2A
24 RO2B
7
25 RO3C
26 RO3A
27 RO3B
X5 Embedded fieldbus
29 B+
30 A- Embedded fieldbus, EFB (EIA-485)
31 DGND
S4 TERM Termination switch
S5 BIAS Bias resistors switch
X4 Safe torque off
34 OUT1
35 OUT2
Safe torque off. Factory connection. Both circuits
36 SGND
must be closed for the drive to start.
37 IN1
38 IN2
X10 24 V AC/DC
40 24 V AC/DC+ in Ext. 24V AC/DC input to power up the control unit
when the main supply is disconnected.
41 24 V AC/DC- in
Total load capacity of the Auxiliary voltage output +24V (X2:10) is 6.0 W (250 mA / 24 V DC).
2
Wire sizes: 0.14...2.5 mm (26...14 AWG): All terminals
Tightening torques: 0.5...0.6 N·m (0.4 lbf·ft)
Ready run
250 V AC / 30 V DC
2 A
Running
250 V AC / 30 V DC
2 A
Fault (-1)
250 V AC / 30 V DC
2 A