Safety Instructions - Klarstein Zermatt Handbuch

SAFETY INSTRUCTIONS

Note: Find a location for the electric heater that is protected from direct sunlight.
Do not plug the electric heater into the power outlet before you read all instructions.
• Please read all instructions carefully before operating the appliance and retain for
future reference.
• Check that the voltage indicates on the data plate corresponds with that of the local
network before connecting the appliance to the mains power supply.
• Never use the appliance unsupervised when in use.
• If you have to leave even for a short moment please stop the appliance.
• Keep out of reach of children and do not allow them to operate this appliance.
• Only use the appliance for domestic purposes and in the way indicated in these
instructions.
• From time to time, check the cord for damage. Never use the appliance if the cord
or any part of the appliance shows signs of damage.
• If the power cord is damaged, it must be replaced by the manufacturer, customer
service or a similarly qualified person in order to avoid a hazard.
• Make sure that the power cord does not touch hot surfaces.
• In order to avoid overheating, do not cover the heater.
• Keep the appliance at least 15 cm from walls and any other thing, to permit a good
air circulation.
• Do not use the appliance outdoors
• Do not use if you have wet hands.
• Never use the appliance on or near hot surfaces.
• Never move the appliance by pulling the cord.
• Before cleaning the appliance, make sure it is unplugged from the power and that it
is completely cooled.
• Do not clean the appliance with abrasive chemicals.
• Never use accessories that are not recommended or supplied by the manufacturer.
It could cause danger to the user or damage to the appliance.
• Never route the mains cable beneath carpet.
• Never use the heater to dry clothes or any other similar items.
• The heater must not be located immediately below a socket outlet.
• This heater must not be used with an extension lead.
• Dot use this heater with a programmer, timer or any other device that switches the
heater on automatically, since a fire risk exists if the heater is covered or positioned
incorrectly.
• In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this
appliance must not be supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on and off by the utility.
• Do not use this heater in the immediate surroundings of a bath, a shower or a
swimming pool.
EN
15