Klarstein Zermatt Handbuch Seite 18

EN
18
2. Flange the chimney head [C and D]. Insert the bottom of the decorative chimney
into the flange on the top of the appliance.
3. After the chimney is stabilized, make the back of the electric fireplace lean against
the wall. When the flange [D] fits the wall, one hand holds the flange [D] and the
other hand removes the electric fireplace and chimney [C].
4. There are 2 fixing holes on the flange [D]. Mark 2 drill holes with a pencil. Drill
2 holes 8 mm in diameter and 43 mm deep on the marked locations. Install the wall
anchors [B] into the holes and gently tap them into place with a hammer until the
flange of the wall anchor [B] is flush with the wall surface.
5. Secure the flange [D] to the wall anchors using the 2 anchor screws [A].
6. Place the electric fireplace in its place and insert the chimney pipe into the flange
on the wall.
7. Plug the power lead in. The electric fireplace is now ready to use.