Atag OX6411LR Betriebsanleitung Seite 47

MAINTENANCE AND CLEANING
2. Hold the inner glass (B) securely with both hands and slide it up to remove it from the initial
position. Do the same with the second glass plate.
Hold the glass panels securely to prevent them from falling.
3. Clean the door with a wet sponge and wipe dry with a soft cloth. Avoid the use of scouring
sponges, steel wool and acidic or abrasive products, as they can damage the surfaces.
Install the glass panels by following the procedure in reverse. The middle glass panel has a small
dot at the top and the second panel has printing. Make sure you place the middle glass plate
in the correct holders. The printed side must face the inside of the door. After installation, make
sure that the surface of the glass panel edge does not feel rough.
B
B
A
EN 21