Klarstein Ilona Brilliant Bedienungsanleitung Seite 29

TROUBLESHOOTING
Fault
Light on, but motor does
not work
Light does not work, motor
does not work.
Light is not working
Oil leakage
Insufficient suction
The range hood inclines.
Note: Any electrical repairs to this appliance must conform to your local, state and
federal laws. Please contact costumer service if in any doubt before undertaking any
of the above. Always disconnect the unit from the power source when opening the
unit.
Energy saving tips
The following shows how to reduce total environmental impact (e.g. energy use) of the
cooking process):
1 Install the cooker hood in a proper place where there is efficient ventilation.
2 Clean the cooker hood regularly so as not to block the airway.
3 Remember to switch off the cooker hood light after cooking.
4 Remember to switch off the cooker hood after cooking.
Possible Cause
Fan switch turned off.
Fan switch failed
Motor failed.
House fuses blown.
Power cord loose or
disconnected.
Lamp is damaged.
One way valve and
the outlet are not tightly
sealed
Leakage from the
connection of chimney
and cover
The distance between the
range hood and the gas
top is too far.
The fixing screws are not
tight enough.
Solution
Select a fan switch
position.
Contact costumer service.
Replace motor.
Reset/Replace fuses.
Refit cord to power outlet.
Have the lamp replaced.
Take down the one way
valve and seal with
sealant.
Take chimney down and
seal.
Refit the range hood to the
correct distance.
Tighten the hanging
screws and align the
range hood horizontal.
EN
29