TermaTech TT23RG Montage- Und Bedienungsanleitung Seite 26

Joints/gaskets can look okay, but they collapse under the heat and thereby lose the ability to
keep the stove sealed. Jointings should be changed as needed as it is important to good combu-
stion and a clean window that the stove is sealed.
The insulation plates in the combustion chamber that are broken or worn can easily be changed
as they are loosely fixed. The material used is called Vermiculite and is a porous, but very suitable
insulation material. It has no effect on the stove's efficiency that the insulation cracks. However, it
should be changed when the wear surpasses half of the original thickness.
Painting the stove with Senotherm-spray can cover spots or small scratches from kettles and
such. Larger damages needs to be ground with fine steel wool, vacuumed and then sprayed.
The can has to be shaken vigorously and then sprayed on at a distance of 15-20 cm. It is very
important that the stove is not in use and completely cold before you use the spray due to the fire
hazard. In order to keep the stove's varnished surfaces looking nice for years to come you should
try to avoid touching the varnished surfaces when the stove is hot. Make sure to have sufficient
ventilation when using spray paint.
Glass normally does not need any maintenance apart from cleaning. This is most easily done
by using TermaTech's glass cleaner. Remember only to use glass cleaner when the stove is cold.
Glass is made of ceramic glass, be sure of environmentally disposal.
Original parts which need to be changed due to wear can be found at your dealer. Because of fit
etc. only original parts from TermaTech should be used.
Right to claim compensation for defective product is under current law. When stating
deviations the use of the product must be suspended immediately and the dealer must be con-
tacted.
Chimney/Flues Must be swept on regular occasions, as per manufacturers recommendations.
5 YEAR WARRANTY* / RIGHT TO INVOKE LACK OF CONFORMITY
5 Year warranty
If defects/faults are ascertained, use of the wood burner must be stopped immediately and the
dealer contacted.
Provided normal operation of the wood burner, TermaTech offers a 5 year warranty on material
and manufacturing faults on the load-bearing frame, exclusive of the combustion chamber.
Combustion chamber The following is not covered by the warranty
Combustion chamber, cast iron parts (bottom, door, grate) insulation material (vermiculite plates)
smoke deflector plates, glass, gaskets, the closing mechanism/handle and the handle.
Exterior parts The following is not covered by the warranty
Varnished plates/surfaces, stone facings, glazed tiles, concrete and glass, as well as the closing
mechanism/handle and magnets.
The warranty does not cover faults which are due to:
• If the user/mounting guide is not being followed
• The mounting has been carried out incorrectly
• Overheating / deterioration of materials, caused by the use of incorrect type of fuel, petro-
leum coke or too much fuel
• that the product has been connected to a chimney with poor drawing qualities. For example
chimneys that are too short or are leaking.
• The product being positioned or has been positioned/kept in unheated or damp surroundings.
• The product being in bad repair or not maintained according to the instructions.
• Normal wear and tear of wearing parts/expendable parts as well as the varnish.
• Similar circumstances which are not due to material or manufacturing faults.
The lesser defects below, which cannot support any claim, can occur in the product:
• Naturally occurring variations in the colour nuances and marbling on the soapstone, sandsto-
ne and other stone cladding.
• Sounds which occur during burning are normal. This occurs when the metal expands and
retracts.
If a fault occurs during delivery to the customer or if such fault arises during the warranty period
which is covered by this warranty, TermaTech A/S agree to send a suitable replacement part free
of charge to rectify the fault. Any additional obligation of TermaTech A/S to remedy the fault, for
example in the form of installation of the replacement part does not exist.
In addition the purchaser has, apart from the right to a replacement part, no right to either
direct or indirect damages.
Repairs of faults or replacements of parts on the product does not extend the product or replace-
26