Working Instructions; Maintenance And Cleaning - Würth EWS 10-125 COMPACT Originalbetriebsanleitung

WARNING!
Risk of severe injuries.
 If the machine is set to continuous
running, it will continue to run if it
is torn out of your hand.
¾ Always hold the machine with both
hands at the handles provided,
take up a stable posture and
concentrate on the work in hand.
Machines with trigger switch
Switch ON
Push the trigger switch [1] forwards.
■
• For continuous operation, then press down-
wards until it engages.
Switch OFF
Press the rear end of the trigger switch [1] and
■
release.
Machines with dead man function
Switch ON
Push the switch-on inhibitor [4] in the direction
■
of the arrow and press trigger switch [3].
Switch OFF
Release trigger switch [3].
■

Working instructions

Grinding
Apply moderate pressure with the machine and
■
move back and forth across the surface so that
the workpiece surface does not become too hot.
Roughing
A good working result is obtained with a
■
working angle of 30° - 40°.
Cut-off grinding
Attention!
¾ Always work up-milling mode during cut-off
grinding!
 Otherwise there is a risk of the machine jump-
ing uncontrolled out of the cut.
Work with moderate feed adapted to the mate-
■
rial being cut. Do not tilt, press or oscillate.
Sanding
Apply moderate pressure with the machine and
■
move back and forth across the surface so that
the workpiece surface does not become too hot.
Working with wire brushes
Apply moderate pressure with the machine.
■

Maintenance and cleaning

WARNING!
Danger of electric current.
¾ Carry out maintenance and
cleaning work on the device only
when the mains plug has been
removed.
CAUTION!
Dusts from materials can be harmful
to health.
¾ Use a dust mask or respirator.
Motor cleaning
Blow out the machine with compressed air
■
through the rear ventilation slots regularly, fre-
quently and thoroughly. Hold the machine firmly
while blowing out.
29