For Your Safety; Safety Instructions - Würth KNS 150-E Originalbetriebsanleitung

GB
Please read and comply with these
instructions prior to the initial
operation of your device.
Retain these instruction manual for
future reference or for subsequent
possessors.
Note
It is not allowed to modify the device
or to manufacture additional devices
for this tool. Such modifications can
cause injuries and malfunctions.
Only authorized and trained personnel are al-
■
lowed to perform repair works on the device. Only
use genuine spare parts from Adolf Würth GmbH
& Co. KG. This ensures continuous device safety.
Special Safety Instructions
Safety Warnings Common for
Grinding, Sanding, Wire
Brushing, Polishing or Abra-
sive Cutting-Off Operations:
This power tool is intended to function
■
as a polisher. Read all safety warnings,
instructions, illustrations and specifica-
tions provided with this power tool.
Failure to follow all instructions listed below may
result in electric shock, fire and/or serious injury.
Operations such as grinding, sanding,
■
wire brushing or cutting-off are not rec-
ommended to be performed with this
power tool. Operations for which the power
tool was not designed may create a hazard and
cause personal injury.
Do not use accessories which are
■
not specifically designed and recom-
mended by the tool manufacturer. Just
because the accessory can be attached to your
power tool, it does not assure safe operation.

For your safety

In case you do not adhere to this instruction
manual and the safety instructions, this may result
in damages on the device and cause dangerous
situations for the operator and other people.
In case of transport damage inform vendor
immediately.

Safety instructions

The rated speed of the accessory must
■
be at least equal to the maximum
speed marked on the power tool. Acces-
sories running faster than their rated speed can
break and fly apart.
The outside diameter and the thickness
■
of your accessory must be within the
capacity rating of your power tool. In-
correctly sized accessories cannot be adequately
guarded or controlled.
The arbour size of wheels, flanges,
■
backing pads or any other accessory
must properly fit the spindle of the
power tool. Accessories with arbour holes
that do not match the mounting hardware of the
power tool will run out of balance, vibrate exces-
sively and may cause loss of control.
Do not use a damaged accessory.
■
Before each use inspect the accessory
such as abrasive wheels for chips and
cracks, backing pad for cracks, tear or
excess wear, wire brush for loose or
cracked wires. If a power tool or acces-
sory is dropped, inspect for damage
or install an undamaged accessory.
After inspecting and installing an acces-
sory, position yourself and bystanders
away from the plane of the rotating
accessory and run the power tool
at maximum no-load speed for one
minute. Damaged accessories will normally
break apart during this test time.
WARNING - Prior to the first
start-up, it is definitely necessary to
read the Safety instructions!
13