Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CONNECTIONS, OPERATING AND DISPLAY ELEMENTS
3
POWER IN
1
Neutrik powerCON TRUE1 mains input socket. Operating voltage 100–240 V AC / 50–60 Hz. A suitable mains cable with powerCON TRUE1
plug is included.
POWER OUT
2
Neutrik powerCON TRUE1 mains output socket. Facilitates power supply to other CAMEO lights. Ensure that the total power consumption of
all devices connected to the device does not exceed the given ampere (A) value.
FUSE
3
Fuse holder for 5 x 20 mm micro fuses. IMPORTANT: Replace the fuse only with a fuse of the same type and value. In the event of repeated
fuse failure, please contact an authorised service centre.
DMX IN
4
Male 3-pin and 5-pin XLR sockets for connection of a DMX control device (e.g. DMX console). Only use the ports alternatively.
5
DMX OUT
Female 3-pin or 5-pin XLR sockets for sending the DMX control signal. Only use the ports alternatively.
NET IN
6
RJ45 network connector for connecting to an Art-Net or sACN network. Use CAT 5e or better cables to set up the network.
NET OUT
7
RJ45 network connector for connecting additional Art-Net or sACN-capable devices to the network. Use CAT 5e or better cables to set up
the network.
ANTENNE FOR W-DMX™
8
The antenna for control via W-DMX™ remains in the holder (= operating position) during operation.
12
9
PRESSURE SENSITIVE LC DISPLAY WITH ILLUMINATION
Thanks to the pressure-sensitive LC display, the device can be operated directly from the display (glove-compatible). The LCD display shows
the currently activated mode (main display), the menu items in the selection menu and the numerical value or operating mode in certain
menu items. If there is no control signal to the device, the display starts flashing; the flashing stops as soon as a control signal is present
(DMX and slave operation, ArtNet and sACN).
6
8
1
2
9
6
4
7
11
5
10
Werbung
Inhaltsverzeichnis
