Cleaning The Electrode Probe And The Test Liquid Absorption Rod - Parkside PPHM 14 A1 Bedienungs- Und Sicherheitshinweise

Switching off: Press and hold /MODE 5 for
approx. 3 seconds.
The product switches off automatically after approx.
10 minutes if no button is pressed during this time.
˜ Cleaning the electrode probe and
the test liquid absorption rod
Pull off the protective cap 12 (if necessary).
Hold the product in such a way that the electrode
probe 1 and the test liquid absorption rod 1a are
facing downward.
Rinse the electrode probe 1 and the test liquid
absorption rod 1a with distilled water for a minimum
of 15 seconds.
Check if the electrode probe 1 and the test liquid
absorption rod 1a are clean. If this should not be the
case, continue rinsing until both parts are cleaned well.
GB/IE 63