Technical Data; Noise Information; Items Included - Bosch GCM 80 SJ Professional Originalbetriebsanleitung

24 | English
(30) Transport safety lock
(31) Scale for bevel angles
(32) Angle indicator for bevel angles
(33) Stop screw for 0° bevel angle
(34) Stop for standard 0° bevel angle
(35) Hex key (5 mm)/cross-headed screwdriver
(36) Hex socket screw for mounting the saw blade
(37) Clamping flange

Technical Data

Sliding mitre saw
Article number
Rated power input
No-load speed
Starting current limitation
Weight according to EPTA-Procedure 01:2014
Protection class
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-
specific models.
Permissible workpiece dimensions (see "Permissible workpiece dimensions", page 27)
Dimensions of suitable saw blades
Saw blade diameter
Base blade thickness
Max. cutting width
Hole diameter

Noise Information

Noise emission values determined according to
EN 62841-3-9.
Typically, the A-weighted noise level of the power tool is:
Sound pressure level 93 dB(A); sound power level
106 dB(A). Uncertainty K = 3 dB.
Wear hearing protection!
The noise emission value given in these instructions has
been measured in accordance with a standardised measur-
ing procedure and may be used to compare power tools. It
may also be used for a preliminary estimation of noise emis-
sions.
The noise emission value given represents the main applica-
tions of the power tool. However, if the power tool is used
for other applications, with different application tools or is
poorly maintained, the noise emission value may differ. This
may significantly increase noise emissions over the total
working period.
To estimate noise emissions accurately, the times when the
tool is switched off, or when it is running but not actually be-
ing used, should also be taken into account. This may signi-
1 609 92A 5UB | (22.10.2020)
(38) Inner clamping flange
(39) Saw blade
(40) Locking screw for the adjustable fence
(41) Holes for screw clamp
(42) Threaded rod
(43) Screws for insert plate
(44) Screw for bevel angle indicator
(45) Screw for mitre angle indicator
W
-1
min
kg
ficantly reduce noise emissions over the total working
period.
mm 216
mm 1,3−1,8
Assembly
mm 3,3
Avoid starting the power tool unintentionally. The
u
mm 30
mains plug must not be connected to the power supply
during assembly or when carrying out any kind of
work on the power tool.

Items included

Check to ensure that all the parts listed below have been
supplied before using the power tool for the first time:
– Sliding mitre saw with mounted saw blade
– Screw clamp (7)
– Saw table extension (3) with fastening set (2 x clamping
screws (2), 2 x cross-head screws to prevent the saw
table extensions from being pulled out of the saw table)
– Hex key/cross-headed screwdriver (35)
Note: Check the power tool for possible damage.
Before continuing to use the power tool, carefully check that
all protective devices or slightly damaged parts are working
perfectly and according to specifications. Check that the
moving parts are working perfectly and without jamming;
GCM 80 SJ
GCM 800 SJ GCM 800 SJ
GCM 8000 SJ GCM 8000 SJ
3 601 M19 0.. 3 601 M19 06.
1400
5500
●
14,1
/ II
See the list of items included at the start of
the operating manual.
Bosch Power Tools
GCM 80 SJ
1250
5500
●
14,1
/ II