ECOVACS ROBOTICS WINBOT 880 Bedienungsanleitung Seite 13

c. Spot Cleaning Mode
This mode can be used for an area with concentrated dirt and dust.
2
Pause
Note: The Direction Control Buttons on the Remote Control cannot be
used until WINBOT is paused.
OR
3. Operating WINBOT
3
Replace the Cleaning Pad
Pause WINBOT and press
WINBOT down. Remove the dirty Cleaning Pad from the WINBOT and
place a clean new one on it.
Note: The gray microfiber side faces out. Make sure the side with
is attached to WINBOT Cleaning Pad Plate with the same
Make sure the Cleaning Pad correctly attached. Do not cover the
Squeegee or Edge Detection Sensors.
on WINBOT for 5 seconds to take
.
13
EN