Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting - ECOVACS ROBOTICS WINBOT 880 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 22
NO.
Malfunction
Remote Control is not paired with
Remote Control
WINBOT (WINBOT comes with a
1
cannot control
paired Remote Control. If Remote
WINBOT.
Control becomes unpaired or has been
exchanged, it can be paired again).
There is too much dirt and debris on the
glass.
The Cleaning Pad is too dirty.
WINBOT moves in
2
an irregular pattern
The Cleaning Pad is too wet.
during cleaning.
The Driving Treads are too dirty.
The Driving Treads are worn.
The Cleaning Pad is attached
WINBOT don't
3
There is a gap on the surface of the glass.
move.
The cleaning pad plate is blocked due to
small obstacles on the glass.
WINBOT move hard
4
The driving treads are stuck.
or in circle.
Possible Causes
Solutions
Within 5 seconds of powering ON WINBOT, press and hold
WINBOT and
on the Remote Control at the same time. Pairing is
complete when WINBOT beeps and flashes RED and GREEN.
A. Spray additional Cleaning Solution on the Cleaning Pad.
B. Clean the Driving Treads as described in section 4.
C. Replace the Cleaning Pad and restart the cleaning cycle.
D. Use the Remote Control to control the cleaning by pressing
Direction Buttons.
E. Clean the window by hand first and use WINBOT for regular
cleaning after that.
* WINBOT is intended to be used for maintenance cleaning on
common windows. The product is NOT designed to replace heavy
duty or first time cleaning.
Please check the surface of the driving treads, see if there is any
heavy wear, crack or breakage. If so, please contact customer service.
Please check the surface of the driving treads, see if there is any
heavy wear, crack or breakage. If so, please contact customer service.
Hold the Safety Tether or WINBOT Power Cord. Meanwhile, press
Direction Buttons on the Remote Control to let the WINBOT leave
the gap or barrier.
Check if there is any dust or debris on the Driving Treads. If so, please
clean the Driving Treads as described in section 4. Start WINBOT
again. If problem persists, please contact customer service.

6. Troubleshooting

on
19
EN

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Winbot wb10g

Inhaltsverzeichnis