ECOVACS ROBOTICS WINBOT 880 Bedienungsanleitung Seite 20

6. Troubleshooting
NO. Malfunction
WINBOT is hanging
around or moves in
5
an irregular pattern
during cleaning.
WINBOT is hanging
around or moves in
6
an irregular pattern
during cleaning.
WINBOT stops
moving after
7
adhered to the
glass.
WINBOT is stuck
and cannot move,
8
be controlled by the
Remote Control.
20
EN
Possible Causes
The bumper rail is stuck.
The bumper rail is broken.
Edge Detection Sensor signal abnormity.
Fan malfunction.
WINBOT is too near to the edge of the
glass or obstacles.
It is stuck by obstacles.
Solutions
Take WINBOT down from the window. Check if the bumper rail is
stuck. Clean the bumper rail and restart WINBOT. If problem persists,
please contact customer service.
A. Remove the Cleaning Pad and re-attach it making sure it will not
cover or affect the Edge Detection Sensors.
B. Clean the Edge Detection Sensors as described in section 4.
C. If the problem persists, please contact Customer Service.
A. Clean the Fan as described in section 4.
B. If the problem persists, please contact Customer Service.
Use the Direction Control buttons on the Remote Control to move
WINBOT away from the problem area and at least 10cm/4" from
window corners and obstacles. Restart WINBOT. Or Remove
WINBOT from the window and put it at least 10cm/4" from window
corners and obstacles. Restart WINBOT.
Fix the safety pod and tether firmly. Hold WINBOT power cord and
meanwhile, use
the Direction Control Buttons to move
WINBOT away from the stuck area. If the problem persists, please
contact Customer Service.