Step 4: Select Color Phase; Step 5: Select Effect Speed - OSRAM e:cue LIGHTDRIVE+ Installationsanleitung

Setup Manual - LIGHTDRIVE+
Proceed to the next step (4) by pressing the Jog-Wheel.
12.4

Step 4: Select color phase

Select the color phase (the depth) of the color effect, either with the Scene buttons
(1), or with the jog wheel. The color phase defines the color spectrum that is being
displayed on all fixtures of selected address range.
y Scene 1: Phase 0 (same color, no color effect)
y Scene 2: Phase 1/4
y Scene 3: Phase 1/2
y Scene 4: Phase 1
y Scene 5: Phase 2
y Scene 6: Phase 3
y Scene 7: Phase 4
y Scene 8: Phase 5 (5 Rainbows are shown on the address range)
If you adjust the values with the jog wheel, an indication is shown if you have
reached the neutral point of this setting. In this case all LEDs are highlighted and a
beep sound is played.
The jog wheel reflects the first selected color, not the color phase. The color phase
can be seen on the connected fixtures.
Proceed to the next step (5) by pressing the Jog-Wheel.
12.5

Step 5: Select effect speed

This step defines the speed of the selected effect. In order to be able to change the
direction of the speed, negative values are be allowed (plus = to ascending DMX ad-
dresses, minus = to descending DMX addresses). The Scene buttons (1) are used to
select predefined values:
y Scene 1: -100% Speed
y Scene 2: -66% Speed
y Scene 3: -33% Speed
y Scene 4: 0 (fixed, Speed = 0)
If you adjust the values with the jog wheel, an indication is shown if you have
24
y Scene 5: +25% Speed
y Scene 6: +50% Speed
y Scene 7: +75% Speed
y Scene 8: +100% Speed
Phase 1/2
Phase 1/4