Step 3: Select Color Phase - OSRAM LIGHTDRIVE+ Installationsanleitung

namic white fixtures the composition. Press a button (1) to select a color, or use the
jog wheel to cycle through all possible colors, depending on the fixture type. The
following colors are predefined:
Monochrome:
y Scene 1: 100% ... Scene
8: 0%
RGB/RGBW:
y Scene 1: color fade
y Scene 2: static rainbow 1 y Scene 6: red
y Scene 3: static rainbow 2 y Scene 7: green
y Scene 4: rainbow
Press the jog (2) wheel to select this color as color and go
to step 3, or long-press Zone C (3) to abort programming. A
short press of Zone C (3) gets you back to step 1.
11.4

Step 3: Select color phase

Select the color phase (the depth) of the color effect, either with the Scene buttons
(1), or with the jog wheel.
y Scene 1: Phase 0 (same color, no color effect)
y Scene 2: Phase 1/4
y Scene 3: Phase 1/2
y Scene 4: Phase 1
y Scene 5: Phase 2
y Scene 6: Phase 3
y Scene 7: Phase 4
y Scene 8: Phase 5 (5 Rainbows are shown on the address range)
The jog wheel reflects the first selected color, not the color phase. The color phase
can be seen on the connected fixtures.
Dynamic White:
y Scene 1: CW ... Scene
8: WW
y Scene 5: white
y Scene 8: blue
Setup Manual - LIGHTDRIVE+
2 1
3
19