Locking The Lightdrive+ Completely; Master And Slave Mode - OSRAM e:cue LIGHTDRIVE+ Installationsanleitung

Setup Manual - LIGHTDRIVE+
11.6

Locking the LIGHTDRIVE+ completely

The LIGHTDRIVE can be locked completely via the front buttons.
y Keep touching the Tone (1) button until you hear a signal
sound. Keep it touched.
y Now touch the Scene 8 button (2), keep both touched
together for at least five seconds.
y The jog wheel blinks in white for five seconds. During this
time, press the jog wheel.
y If you do not press the jog wheel, the LIGHTDRIVE+ will
return to normal operation.
The LIGHTDRIVE+ is now locked completely. Signals over
the digital inputs like Scene selection are still accepted. To
unlock the LIGHTDRIVE+, repeat the steps above, this time
without acoustic signaling or power down the device. The
locking will also be disabled when the state of the digital inputs changes.
11.7

Master and slave mode

The LIGHTDRIVE+ supports different master and slave modes to synchronize several
LIGHTDRIVE+ devices via the TCP/IP port. This includes a multimaster, a master and
a slave mode. Please use the multimaster mode if you have several LIGHTDRIVE+
that should synchronize their currently running scene automatically. Please use the
master mode if one master is supposed to control several slave devices or use the
slave mode if you would like a LIGHTDRIVE+ to react on button presses of a master
with the same Class ID.
While setting up a multimaster or a master/slave system please
i
keep in mind that only devices with the same Class ID are linked
to each other.
The master or slave mode is set with the LIGHTDRIVE+ Configurator application.
20
3
2
1