Advanced Programming; Programming Logic - OSRAM e:cue LIGHTDRIVE+ Installationsanleitung

12

Advanced programming

The advanced programming mode allows creation of more complex scenes with ef-
fects or specific fixture settings.
For the advanced programming mode, the "Tone enable" and
i
"Save Scenes" DIP switches have to be set to the "on" position.
To start the advanced programming mode, first select the Zone to work on.
y Keep touching the Tone (1) button until you hear a signal
sound. Keep it touched.
y Now touch the Scene 1 button, keep both touched
together for at least five seconds.
y Two beep sounds signal entering this programming
mode and all bars and LEDs will blink two times.
y The lowest bar keeps on blinking. The Scene 1 LED is
alight. The third Zone button is also blinking.
The LIGHTDRIVE+ does not return to standard mode auto-
matically from now on.
12.1

Programming logic

The advanced programming mode is used to create more advanced and complex
scenes and runs through seven steps. Each step is marked by an alight Scene LED,
beginning from 1 to 7. Also in each step a value or function is selected by the jog
wheel or by the Scene buttons.
y Step 1: Select the channel types for RGBW (Scene 1 LED is alight)
y Step 2: Select the effect block size (Scene 2 LED is alight)
y Step 3: Select the color (Scene 3 LED is alight)
y Step 4: Select the color phase (Scene 4 LED is alight)
y Step 5: Select effect speed (Scene 5 LED is alight)
y Step 6: Define dimming level (Scene 6 LED is alight)
y Step 7: Assign to settings to scene (all Scene button LED are alight)
Setup Manual - LIGHTDRIVE+
2
1
21