Mounting; Unmounting - OSRAM e:cue LIGHTDRIVE+ Installationsanleitung

Setup Manual - LIGHTDRIVE+
6

Mounting

The LIGHTDRIVE+ can be mounted in most standard wall-mount boxes (DE, US, UK,
JP etc.). It is recommended to install it in a double-box to have room for the cabling.
Place the LIGHTDRIVE+ on the base plate so all
four noses of the base plate rest in the four holes of
the LIGHTDRIVE+. Shift down the LIGHTDRIVE+
until the locker latches with a small click.
Keep the shielding and twisting of the Ethernet
wires as long as possible to ensure proper Ether-
net connections.
Do not over-tighten the mounting screws for the base plate. This
!
may damage the holes for the screws or the base plate gets
twisted..
6.1

Unmounting

To unmount the LIGHTDRIVE+, insert a narrow screw driver into the small hole in the
bottom right side to unlock the latch. Shift the LIGHTDRIVE+ slightly up until it gets
fully released.
12
Mount the base plate for the LIGHTDRIVE+ with the pro-
vided screws on the wall-mount boxes, recess to the
top. Use a spirit level to ensure proper positioning. Use
as many of the appropriate fixing holes of the base plate
as possible. Make all required connections to the LIGHT-
DRIVE+