OSRAM e:cue LIGHTDRIVE+ Installationsanleitung Seite 22

Setup Manual - LIGHTDRIVE+
In every step, the connected fixtures show the current state of the Scene, e. g. color,
effect or brightness.
Abort the advanced programming mode at any point by keeping
i
the Zone C button touched for at least five seconds.
Touching the Zone C button once returns to the previous step.
During advanced editing no time-out of this mode occurs, like changing Tone or
speed in standard mode. Either you execute the complete programming and save
the Scene, or you abort the programming with a long touch of the Zone C button.
Step 1: Select the channel types for RGBW (only in RGBW Mode)
When the DIP switches are not set to fixture type RGBW, this step is skipped by
the LIGHTDRIVE+. As RGBW fixtures have many control possibilities you can select
specifically how the RGB and white channel are used for the remaining steps of the
advanced programming mode.
y Step 1: White channel only, RGB off
y Step 2: White channel off, RGB only
y Step 3: RGB, 100% White (fixed channel value)
y Step 4: RGB, 10% White (fixed channel value)
...
y Step 12: RGB, 90% White (fixed channel value)
y Step 13: RGB+W (color cycle with adjustable white
level)
Use the Scene Buttons to select the following configurations:
y Scene 1: White channel only, RGB off y Scene 5: RGB, 25% White (fixed)
y Scene 2: White channel off, RGB only y Scene 6: RGB, 50% White (fixed)
y Scene 3: RGB, 100% White (fixed)
y Scene 4: RGB, 15% White (fixed)
Proceed to the next step (2) by pressing the Jog-Wheel.
22
Control white channel
Control RGB channel +
xed intensity for white
y Scene 7: RGB, 75% White (fixed)
y Scene 8: RGB+W (color cycle
with adjustable white level)
Step 1: Step 2:
Control RGB channel
only only
Step 3-12: Step 13:
Control RGB+W based
on a color circle with
channel adjustable white level
x