Jog Wheel; Zones; Scenes - OSRAM e:cue LIGHTDRIVE+ Installationsanleitung

When the LIGHTDRIVE+ is not used, the bars and LEDs are dimmed down after 30
seconds (default). It returns to the active state when the job wheel is turned or any
button is touched. The integrated proximity sensor also reactivates the device, when
the user approaches the LIGHTDRIVE+. Reactivation does not change the selected
Zone or Scene. After switching off the device and switching it on again, the LIGHT-
DRIVE+ restores the same state as selected before.
change these default DMX address range for Zone B/C. See chapter „13 Complete
programming" where to download this application.
11.3

Scenes

Select a Scene for the current Zone by touching one of the eight Scene buttons.
The right Scene number lights up, a signal sound indicates the selection of a Scene.
The following scenes are preconfigured for the different fixture types (see chapter "8.1
Fixture Types") on the LIGHTDRIVE+:
11.1

Jog wheel

Use the jog wheel to switch the LIGHTDRIVE+
on and off. Switching is done by pressing the jog
wheel. In standard mode, the jog wheel controls the
brightness (CW = higher, CCW = lower). The jog
wheel also shows the current color of the fixtures.
If the LIGHTDRIVE+ is in OFF Mode, you can
change the appearance of the jog wheel illumina-
tion (pulsative or static) by turning the jog wheel.
11.2

Zones

Select a zone with of the three Zone buttons. A sig-
nal sound indicates the zone selection. The LIGHT-
DRIVE+ controls three Zones:
Zone A: DMX 1, addresses 1 ... 512
y
Zone B: DMX 2, addresses 1 ... 256
y
Zone C: DMX 2, addresses 257 ... 512
y
The application LIGHTDRIVE+ Configurator can
Setup Manual - LIGHTDRIVE+
17