Fixture Types; Zones; Control All Zones Via Zone A - OSRAM e:cue LIGHTDRIVE+ Installationsanleitung

8.1

Fixture types

A B Fixture type
1 0 Monochrome
1 1 Dynamic White
0 0 RGB
0 1 RGBW
8.2

Zones

The LIGHTDRIVE+ can control three different zones, which can be selected from the
front panel.
Zones
A DMX 1, DMX addresses 1 ... 512
B DMX 2, DMX addresses 1 ... 256 (default value)
C DMX 2, DMX addresses 257 ... 512 (default value)
8.3

Control all Zones via Zone A

If DIP switch 9 is set to enabled, Zone control for the Zones B and C is linked to Zone
A (including brightness levels) with the following modifications.
y If Zone A is selected, Scene control in this Zone is also valid for B and C. Relay
settings are only used as defined for Zone A, relay settings for Zones B and C are
ignored.
y If Zone B or C are selected, all control works as defined, including relay settings.
In this way, you can control all Zones, if Zone A is selected. With Zones B and C
selected, you have separate control for the current Zone.
Setup Manual - LIGHTDRIVE+
15