Tone; Saving Scenes - OSRAM e:cue LIGHTDRIVE+ Installationsanleitung

11.4

Tone

Use of the Tone button and saving Scenes requires that the
i
corresponding DIP switches (DIP switch 8 & 10) on the back are
set to the "on" position.
The Tone button has three different modes.
y If the Zone LED and the Zone bar are constantly alight, the jog wheel controls
the brightness. The Tone LED and the Tone bar are off. The LIGHTDRIVE+ is in
standard mode.
y A short touch of the Tone button switches to color mode. A short signal sound is
played. The Tone LED now blinks and you can select a color with the jog wheel.
The jog wheel and the Tone bar reflect the current color. Touch the Tone button
again to leave Tone mode without saving changes.
y A long press of five seconds switches to speed mode for effects. Again, a signal
sound is played. The Tone LED blinks and the Tone bar flashes. You now can
select the speed of the current effect, the Tone bar blinks with the speed of the ef-
fect. If the speed is zero, the Tone bar is constantly alight. Touch the Tone button
again to return to standard mode without changes.
A short press of the Tone button returns to standard mode. If there is no action within
30 seconds, the LIGHTDRIVE+ returns to the dimmed state and the mode returns to
standard mode. After switching on the LIGHTDRIVE+, the Tone function is always in
standard mode for controlling the brightness of the fixtures.
In any case, the button of the jog wheel shows the current color of the Scene for the
current selected Zone, wether saved or not.
Press shortly any Scene button to exit editing mode and to return to normal opera-
tion. Note that changes are omitted.
11.5

Saving Scenes

Usually you save Scenes after changing the Tone or the speed of an effect. A Scene
can be saved by a long press of five seconds on a Scene button. The Scene consists
of color or effect, dimming and effect settings. A signal sound affirms the saving of
the Scene.
Setup Manual - LIGHTDRIVE+
19