Master And Slave Mode; Advanced Programming; Programming Logic - OSRAM LIGHTDRIVE+ Installationsanleitung

10.6

Master and slave mode

The LIGHTDRIVE+ supports a master and slave mode to synchronize several LIGHT-
DRIVE+ devices. This includes a multi-master mode, one master controls several
slave devices or there are more than one master, so all devices may be synchronized
with more than one master.
Master or slave mode is set with the LIGHTDRIVE+ Configurator application.
11

Advanced programming

The advanced programming mode allows creation of more complex scenes with ef-
fects or specific fixture settings.
For the advanced programming mode, the "Tone enable" and
i
"Save Scenes" DIP switches have to be set to the "on" position.
To start the advanced programming mode, first select the Zone to work on.
y Keep touching the Tone (1) button until you hear a signal
sound. Keep it touched.
y Now touch the Scene 1 button, keep both touched
together for at least five seconds.
y Two beep sounds signal entering this programming
mode and all bars and LEDs blink two times.
y The lowest bar keeps on blinking. The Scene 1 LED also
blinks.
The LIGHTDRIVE+ does not return to standard mode auto-
matically from now on.
11.1

Programming logic

The advanced programming mode runs through six steps. Each step is marked by
an alight Scene LED, beginning from 1 to 6. Also in each step a value or function is
selected by the jog wheel or by the Scene buttons.
At any point you can return to the previous step with the third Zone button (second
button from below), if there is a previous step. Keeping this button touched for at
Setup Manual - LIGHTDRIVE+
2
1
17