Standard Use; Jog Wheel; Zones - OSRAM LIGHTDRIVE+ Installationsanleitung

10

Standard use

The LIGHTDRIVE+ controls up to two DMX universes. This address range is split into
three Zones. To any Zone a Scene can be assigned, a Scene can be a constant color
or effect, and a brightness level. To select Zones and assign Scenes, touch-sensitive
button are used. To change the brightness turn the jog wheel. To switch the LIGHT-
DRIVE+ on and off, press the jog wheel. The color in the current selected Zone is also
used to illuminate the jog wheel while it is not in dimmed or sleep mode.
When the LIGHTDRIVE+ is not used, the bars and LEDs are dimmed down after 30
seconds (default). It returns to the active state when the job wheel is turned or any
button is touched. The integrated proximity sensor also reactivates the device, when
the user approaches the LIGHTDRIVE+. Reactivation does not change the selected
Zone or Scene. After switching off the device and switching it on again, the LIGHT-
DRIVE+ restores the same state as selected before.
10.1

Jog wheel

Use the jog wheel to switch the LIGHTDRIVE+
on and off. Switching is done by pressing the jog
wheel. In standard mode, the jog wheel controls the
brightness (CW = higher, CCW = lower). The jog
wheel also show the current color of the fixtures.
10.2

Zones

Select a zone with of the three Zone buttons. A sig-
nal sound indicates the zone selection. The LIGHT-
DRIVE+ controls three Zones:
Zone A: DMX 1, addresses 1 ... 512
y
Zone B: DMX 2, addresses 1 ... 256
y
Zone C: DMX 2, addresses 257 ... 512
y
See chapter „12 Complete programming" how to
change the split point of the universe DMX 2.
Setup Manual - LIGHTDRIVE+
15