After Operation; Cleaning Under The Machine - Toro 48cm 60V Super Recycler Bedienungsanleitung

After Operation

Cleaning under the Machine

Service Interval: Before each use or daily
For best results, clean the machine soon after you
have completed mowing.
1. Move the machine onto a flat paved surface.
2. Shut off the motor and wait for all moving parts
to stop before leaving the operating position.
3. Lower the machine to its lowest cutting-height
setting. Refer to
(page 13).
4. Wash out the area under the rear door where the
clippings go from the underside of the machine
to the grass bag.
Note:
Wash out the area with the
bag-on-demand (if equipped) in both the fully
forward and fully rearward positions.
5. Attach a garden hose that is connected to a
water supply to the washout port
Figure 19
1. Washout port
6. Turn the water on.
7. Start the motor and run it until the clippings no
longer come out from under the machine.
8. Shut off the motor.
9. Shut off the water and disconnect the garden
hose from the machine.
10. Start the motor and run it for a few minutes to
dry the underside of the machine to prevent it
from rusting.
11. Shut off the motor and allow it to cool before
storing the machine in an enclosed area.
Adjusting the Cutting Height
(Figure 19).
g335823
18