Recycling The Clippings; Bagging The Clippings - Toro TurfMaster 22207 Bedienungsanleitung

Recycling the Clippings

This machine comes from the factory ready to recycle
grass and leaf clippings back into the lawn. To prepare
the machine to recycle:
•
If the side-discharge chute is on the machine,
remove it and install the side-discharge deflector;
refer to Removing the Side-Discharge Chute
(page 18).
•
If the grass bag is on the machine, remove it; refer
to Removing the Grass Bag (page
•
If the rear-discharge plug is not installed, grip it by
the handle, raise the rear deflector, and insert it
into the rear-discharge chute until the latch locks
into place; refer to Figure

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf clippings from the lawn.
If the side-discharge chute is on the machine, remove it and install the side-discharge deflector before bagging
the clippings; refer to Removing the Side-Discharge Chute (page
Installing the Grass Bag
1. Raise and hold up the rear deflector (A of
2. Remove the rear-discharge plug by pulling down on the latch with your thumb and pulling the plug out
from the machine (B of
3. Install the bag rod into the notches at the base of the handle, and rock the bag back and forth to ensure
that the rod is seated at the bottom of both notches (C of
4. Lower the rear deflector until it rests on the grass bag.
Removing the Grass Bag
To remove the bag, reverse the steps in
All manuals and user guides at all-guides.com
17).
20.
Figure
Figure 21).
Figure 21
Installing the Grass Bag (page
1. Rear-discharge plug
18).
21).
Figure 21).
17).
17
Figure 20
2. Rear deflector
g019812
g235892