Fuel Safety; Filling The Fuel Tank; Checking The Engine-Oil Level - Toro 53cm Super Recycler 20792 Bedienungsanleitung

Fuel Safety

DANGER
Fuel is extremely flammable and highly
explosive. A fire or explosion from fuel
can burn you and others and can damage
property.
• To prevent a static charge from igniting the
fuel, place the container and/or machine
directly on the ground before filling, not in
a vehicle or on an object.
• Fill the fuel tank outdoors, in an open area,
when the engine is cold. Wipe up any fuel
that spills.
• Do not handle fuel when smoking or
around an open flame or sparks.
• Store fuel in an approved container and
keep it out of the reach of children.
WARNING
Fuel is harmful or fatal if swallowed.
Long-term exposure to vapors can cause
serious injury and illness.
• Avoid prolonged breathing of vapors.
• Keep your hands and face away from the
nozzle and the fuel-tank opening.
• Keep fuel away from your eyes and skin.

Filling the Fuel Tank

•
For best results, use only clean, fresh, unleaded
gasoline with an octane rating of 87 or higher
((R+M)/2 rating method).
•
Oxygenated fuel with up to 10% ethanol or 15%
MTBE by volume is acceptable.
•
Do not use ethanol blends of gasoline, such
as E15 or E85, with more than 10% ethanol by
volume. Performance problems and/or engine
damage may result, which may not be covered
under warranty.
•
Do not use gasoline containing methanol.
•
Do not store fuel either in the fuel tank or in fuel
containers over the winter unless fuel stabilizer
has been added to the fuel.
•
Do not add oil to gasoline.
Fill the fuel tank with fresh unleaded regular gasoline
from a major name-brand service station
Important:
To reduce starting problems, add
fuel stabilizer to the gasoline all season. Mix the
stabilizer with gasoline less than 30 days old.
Refer to your engine owner's manual for additional
information.
Checking the Engine-Oil
Level
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
1. Dipstick
2. Add
3. Wipe the dipstick clean with a clean cloth.
4. Insert the dipstick into the oil-fill tube, then
remove the dipstick.
5. Read the oil level on the dipstick
•
(Figure 11).
10
Figure 11
Figure 12
3. Full
If the oil level on the dipstick is too low
(Figure 12), carefully pour a small amount
of SAE 30 or SAE 10W-30 detergent oil into
the oil-fill tube, wait 3 minutes, and repeat
steps 3 through 5 until the oil on the dipstick
g027629
(Figure 6).
g187518
(Figure 12).