Inputs; Outputs - Omnitronic MCP-8150 Bedienungsanleitung

Inputs

A good cable run improves the sound quality remarkably. Input cables should be short and direct, since high
frequencies will mostly be absorbed if the cables are unnecessarily long. Besides that a longer cable may
lead to humming and noise trouble. If long cable runs are unavoidable, you should use balanced cables.
Professionals recommend to connect the input-cables via balanced XLR-jacks or terminal blocks.
Occupation balanced XLR-connection:
Input
Occupation jack plug:
Unbalanced use of
mono 1/4" jack plugs
Tip =
Signal (+)
Sleeve =
Ground / Shield
Tip
Sleeve
Strain relief clamp

Outputs

The high damping factor of your amplifier supplies a clear sound reproduction. Unnecessarily long and thin
cables will influence the damping factor and thus the low frequencies in a negative way. In order to
safeguard good sound quality, the damping factor should lie around 50. The longer a cable has to be, the
thicker it should be.
Connect your speaker-systems via the terminal blocks.
Balanced use with XLR connectors
2 1
1 = Ground / Shield
2 = Hot (+)
3 = Cold (-)
3
For unbalanced use pin 1 and pin 3 have to be bridged
24/29
1 2
3
Balanced use of
stereo 1/4" jack plugs
Tip =
hot (+)
Ring =
cold (-)
Sleeve =
Ground / Shield
Tip
Ring
Sleeve
Strain relief clamp
For connection of balanced and
unbalanced plugs, ring and sleeve have
to be bridged at the stereo plug.
Output
10452430_V_1_0.DOC