Yard Force SA900 Originalanleitung Seite 58

6 EF 06 Warning message
7 EF 07 Warning message
8 EF 08 Warning message
9 EF 09 Warning message
10 EF 10 Warning message
TROUBLESHOOTING
Your Mower is or
has been outside of
the boundary wire.
The Mower cannot
receive the signal
sent from the
boundary wire
Battery voltage is
too low to perform
normal mowing.
Drive motor maybe
locked
Cutting motor be
maybe locked
55
1. If the Mower is still inside the
boundary area when the display
shows OUTSIDE please check
if the boundary is connected
correctly.
2. If the Mower is outside of the
boundary put it back into the
inside area and restart.
3. If the Mower runs outside of
boundary at a corner, please
adjust and enlarge the corner
angle to exceed 90°.
4. If the Mower runs outside
of the boundary at one place
several times please check
if there is a high power cable
nearby or underneath if it is the
case please avoid that area by
changing the position of the
boundary wire if possible.
1. Check if the charging station
indicator light is green
2. Check if charging station
is connected with power if
indictor light is not lit.
3. If the indicator light is red,
please check if the boundary
wire is connected to charging
station.
4. If it is your first use after
power off carry to nearby
boundary.
1. Normally if voltage is low, the
Mower should automatically
return to the charging station.
2. If not, please carry your
Mower manually to charging
station when it has stopped on
the lawn.
Power off then Restart mower.
If the fault still exists after
mower is restarted, please call
after sales service.
Power off then Restart mower.
If the fault still exists after
mower is restarted, please call
after sales service.