Yard Force SA900 Originalanleitung Seite 19

UNDERSTANDING THE ROBOTIC MOWER
3.2.4. YARD FORCE Robotic Mower Mowing Limitations
The YARD FORCE robotic lawnmower is programmed by manufacturer to cut 24 hours, 7
days a week but as every garden will be different and if you want to change these settings,
it is easy to program this by yourself see instructions which listed at follow chapter.
If your neighbor is using a YARD FORCE Robotic Lawnmower also, you need keep a 0.5 m
distance between your and neighbor's boundary wires to eliminate interference. And you
need keep your charging station more than 10m from your neighbor's boundary wires, and
you have to set a different boundary signal from neighbor's as signal S1 or S2. Ref. 5.5.3
"Signal setting".
Below is a table showing the signal distances for each of the Robot Mowers, please note
your model and use this information as your guide when designing the boundary layout.
Distance of receive the signal
Model Max field
L
2
SA900 900 m 15 m
NOTE ! 2
When the working area is less than 100 m or total boundary wire less than 40
m, please connect a 20 Ω / 2 W cement resistance to the boundary wire, or contact the
service.
3.2.5. YARD FORCE Robotic Mower Cutting Information
The YARD FORCE Robotic Lawnmower has 5 cut height settings between 20mm to 60mm.
If the grass height is higher than 60cm, you need cut this grass down to at least 60mm,
otherwise the load on the unit will be too large and the cutting efficiency will suffer. Use
a normal lawn mower or a grass trimmer. Once the installation is completed, the cut can
be adjusted to one of the 5 settings of your choice. Always start in a high cutting position
and work yourself down to the cutting height you want. This is carried out by lifting the lid
shown and adjusting the large rotating dial here. Note do not attempt to raise or lower the
cut height during cutting and always.
16