Yard Force SA900 Originalanleitung Seite 33

Once these connections are made, plug in power supply, there is a blue LED Light on
charging station, see below and if all is ok, it should light up with constant green. If no LED
is lit, check the power connections firstly, if LED is on but not constant green refer to the
trouble shooting guide below.
LED
1 Blue light on
2 Blue flash, Red off Charging station internal wire break, main Boundary is OK
3 Red flash, Blue off
4 Red and Blue flash
LED
4.7. Turn On and Test the Installation
Once the LED light is constant green, this means all is ok so now the Boundary wire pegs
can be knocked fully with hammer. Once this is done, double check the light is still blue
if yes then the boundary and charging station are all working as normal. Then place the
YARD FORCE Robotic Lawnmower in the working area, a few meters beside the charging
station.
INSTALLATION GUIDE
Normal
Boundary cut off or poor connect, charging station internal wire
is OK
Boundary and charging station internal wire both short circuit or
cut off
30
Description