Yard Force SA900 Originalanleitung Seite 56

5
message
fixed
Warning
6
message
Warning
7
message
flash
Warning
8
flash message
Warning
9
message
flash
TROUBLESHOOTING
Note Back to charging
station
Battery voltage is
too low to perform
normal mowing.
Your Mower has
been lifted during
use for some
reason
The Mower cannot
receive the signal
sent from the
boundary wire
Your Mower is or
has been outside
of the boundary
wire.
Proper function
1. Normally if voltage is low, the
Mower should automatically
return to the charging station.
2. If not, please carry your Mower
manually to charging station
when it has stopped on the lawn.
1. Check if the lifting is caused by
too high grass (taller than 60mm).
If souse a normal lawn mower
to cut the grass before you start
your mower again.
2. Check the mower is free from
obstructions.
1. Check if the charging station
indicator light is green
2. Check if charging station is
connected with power if indictor
light is not lit.
3. If the indicator light is red, please
check if the boundary wire is
connected to charging station.
4. If it is your first use after power
off carry to nearby boundary.
5. Check your choice Signal A1 or
A2 in control panel if same as
charging station setting.
1. If the Mower is still inside the
boundary area when the display
shows OUTSIDE please check
if the boundary is connected
correctly.
2. If the Mower is outside of the
boundary put it back into the
inside area and restart.
3. If the Mower runs outside of
boundary at a corner, please
adjust and enlarge the corner
angle to exceed 90°.
4. If the Mower runs outside of the
boundary at one place several
times please check if there is
a high power cable nearby or
underneath if it is the case please
avoid that area by changing the
position of the boundary wire if
possible.
53