Switching On / Start - Stop; Switching Off; Setting The Temperatures - Julabo TW2 Betriebsanleitung

Operating procedures
7.2.

Switching on / Start - Stop

7.3.

Setting the temperatures

Notice:
When the working temperature is higher than 50 °C, it might happen that due
to strong production of steam there is considerable dripping on the inside of
the lift-up Makrolon
be tempered.
 Always properly seal all sample containers.
42
• Switching on:
Turn on the mains power switch (1).

The unit performs a self-test. All segments of the 4-digit LED
temperature DISPLAY and all indicator lights will illuminate.
Then the software version (example: n 11.0) appears.
Together with the display of the water bath temperature the
operating state is also displayed. (Example: 18.5 °C)
The heat-up phase is indicated by the yellow heating control light
which will blink in regular intervals when the selected
temperature has been attained.

• Switching off:

Turn the unit off with the mains power switch.

Setting can be carried out in the start/stop condition.
1.
Press one of the keys
value instead of the actual value is indicated on the display for
about 8 seconds. The value can now be changed.
2.
Change value:
Press to set a higher value.
Press to set a lower value.
Keep the keys depressed for the value to change fast.
3.
Press enter

cover. Some drops may fall directly into the material to
for a short moment. The setpoint
to store the value.