Installation, Power Supply - piezosystemjena nano box Bedienungsanleitung

CAUTION!

Allow adequate ventilation around the units so that heat can properly dissipate.
Do not block ventilated openings or place the units near a radiator, oven or other
heat sources. Do not put anything on top of the units except those that are
designed for that purpose (e.g. actuators).

Do not place any heavy objects on any cables (e.g. power cords, sensor cables,
actuator cables, optical cables). Damage may cause malfunction or shock or fire!

Do not place the units on a sloping or unstable cart, stand or table as they may
fall or not work accurately.

Work with the units only in a clean and dry environment! Only specially prepared
units (e.g. actuators) can work under other conditions!

Please use only original parts from piezosystem jena.

piezosystem jena does not give any warranty for damages or malfunction
caused by additional parts not supplied by piezosystem jena. Additional cables
or connectors will change the calibration and other specified data. This can
change the specified properties of the units and cause them to malfunction.

Piezo elements are sensitive systems capable of the highest positioning
accuracy. They will demonstrate their excellent properties only if they are
handled correctly! Please mount them properly only at the special mounting
points.
Immediately unplug your unit from the wall outlet and refer servicing to qualified
service personnel under the following conditions:

when the power supply cord or plug is damaged

if liquid has been spilled or objects have fallen into the unit

if the unit has been exposed to rain or water

if the unit has been dropped or the housing is damaged

6.1. installation, power supply

RISK OF ELECTRIC SHOCK

Do not insert or unplug the power adaptor with wet hands, as this may result in
electrical shock.

Do not install in rooms, where inflammable substances are stored. If flammable
substances come into contact with electrical parts inside, this may result in fire or
electrical shock.
Geschäftsführer: Dr. Bernt Götz • Telefon 03641/66880 • Fax 03641/668866 • www.piezosystem.com
5