Important Safety Information; Rack Requirements For Versarails; Four-Post Rack Installation; Rack Stabilizer Feet - Dell POWERVAULT MD1120 Rack-Installationsanleitung

Important Safety Information

Observe the safety precautions in the following subsections when installing
your system in the rack.

Rack Requirements for VersaRails

Four-Post Rack Installation

Before attempting this installation, read through this entire procedure
carefully.

Rack Stabilizer Feet

The stabilizer feet help prevent the rack from tipping over. See the
documentation provided with the rack cabinet for instructions on installing
and anchoring the stabilizer feet.
Downloaded from www.Manualslib.com
CAUTION:
You must strictly follow the procedures in this document to protect
yourself as well as others who may be involved. Your system may be very large
and heavy and proper preparation and planning are important to prevent injury
to yourself and to others. This precaution becomes increasingly important when
systems are installed high up in the rack.
CAUTION:
Do not install rack kit components designed for another system.
Use only the rack kit for your system. Using the rack kit for another system may
result in damage to the system and personal injury to yourself and to others.
NOTICE:
The VersaRails rack kit is intended to be installed by trained service
technicians in a rack that meets the specifications of American National Standards
Institute (ANSI)/Electronic Industries Association (EIA) standard ANSI/EIA-310-
D-92, International Electrotechnical Commission (IEC) 297, and Deutsche Industrie
Norm (DIN) 41494. One rack kit is required for each system that is installed in a rack.
CAUTION:
Before installing systems in a rack, install front and side stabilizers on
stand-alone racks or the front stabilizer on racks joined to other racks. Failure to
install stabilizers accordingly before installing systems in a rack could cause the
rack to tip over, potentially resulting in bodily injury under certain circumstances.
Therefore, always install the stabilizer(s) before installing components in the rack.
manuals search engine
Rack Installation Guide
7