Cleaning And Maintenance; Troubleshooting - Concept LO7030 Bedienungsanleitung

NOTE: Always use the tamper to push food through the stuffing opening. Never push in food using your fingers,
a fork, spoon, knife or any other object.
8. Continuously check the volume of pulp in the container, or stuck to the upper lid, and the clearness of the juice drain.
The juice drain cannot be clogged. Before you open the upper lid, wait until the rotating sieve stops. Release the
upper lid by tipping the locking clip, clean it, empty the pulp container, clean the rotating sieve and remove the
remaining pulp from the juice drain cover.
WARNING!
If the noise level becomes considerably higher, or there are stronger vibrations, clean the unit immediately!
9. Turn the unit off after use, disconnect from the power socket, remove the pulp and clean the individual parts (see

Cleaning and maintenance).

NOTE: Extracted juice is designed for immediate consumption, as it oxidizes very fast in the open air, which can
worsen the taste, change the color and, most importantly, decrease the nutritional value.
Apple or pear juice turns brown fast; you can slow down this process by adding a few drops of lemon juice.
The juice container is not designed for keeping juice or other food!
CLEANING AND MAINTENANCE
Before cleaning the unit, always disconnect the power cord from the wall outlet!
The surface of the unit may only be cleaned using a wet cloth. Do not use any
detergents or hard objects, as they may damage the unit's surface!
Wash the removable parts in warm water. Use the supplied brush.
Never clean the unit under running water, do not rinse it, and do not
submerge it in water!
1. Release the locking clip by pulling upwards and tipping it.
2. Open the upper cover.
3. Release the juice drain cover upwards together with the rotating sieve.
4. Remove and clean the pulp container.
5. After you finish cleaning the removable parts, follow the reverse steps to
reassemble the unit.

TROUBLESHOOTING

Problem
Motor does not run.
34
Cause
Plug inserted into the mains outlet
incorrectly or insufficiently.
The mains outlet is not live.
Wrongly assembled upper cover or
closing clip.
Supply cable is damaged.
Solution
Check the plug connection.
Check for voltage, e.g. by connecting another
appliance.
Check assembly of the unit.
Refer the unit to an authorized service center
for testing and repair.
EN
LO7030