Cleaning And Maintenance - Concept LO7020 Handbuch

EN
• It is usual that when processing apples and bananas no juice is extracted.
• To achieve maximum effectiveness of the unit, clean the rotating sieve after every half kilogram of processed
food.
Extraction
1. Fix the pulp bin to the side of the unit (Fig. 1).
2. Fix the juice drain cover to the upper part of the body.
3. Apply the rotating sieve to the juice drain cover by pressing on the upper edge
of the sieve downwards.
4. Put on the upper lid, and fix it with the locking clip (Fig. 2).
5. S elect the required speed according to the processed food using the speed
switch. The higher speed is suitable for food with low juice content (apples,
carrots, etc.). The lower speed is suitable for food with high juice content (pears,
oranges, peaches, etc.).
6. O pen the juice drain downwards to let the extracted juice flow into a bowl.
7. I nsert washed pieces of food in the feeder slowly.
You can feed in whole apples and pears, or you may cut them into pieces. You
don't have to peel them or remove the cores.
Peel oranges first, feed in only individual grapes.
It is difficult to extract juice from bananas, avocados, blackberries, figs,
strawberries, etc.
NOTE: Always use the stuffer to push food through the stuffing opening. Never
push in food using your fingers, a fork, spoon, knife or any other object
(Fig. 3).
8. C ontinuously check the volume of pulp in the bin, or stuck to the upper lid. If
the pulp needs to be removed, turn the unit off and wait until the rotating sieve
stops. Close the juice drain upwards. Release the upper lid using the closing
lock, clean it, empty the pulp bin and clean the rotating sieve.
9. A fter use turn off the product and unplug from the mains outlet.
NOTE: Extracted juice is designed for immediate consumption, as it oxidizes
very fast in the open air, which can make its taste worse, change its color and,
most importantly, decrease its nutritional value.
Apple or pear juice turns brown fast; you can slow down this process by adding a
few drops of lemon juice.

CLEANING AND MAINTENANCE

Before cleaning the unit, always disconnect the power cord from the wall outlet!
The surface of the unit may only be cleaned using a wet cloth. Do not use any
detergents or hard objects as they may damage the unit's surface!
Wash the removable parts in warm water.
Never clean the unit under running water, do not rinse it, and do not
submerge it in water!
1. Open the closing clip.
2. Open the upper cover.
LO7020
Fig. 1
Fig. 2
Fig. 3
Fig. 4
23