Cleaning And Maintenance - Concept LO 702-Serie Bedienungsanleitung

Extraction
1. Fix the pulp bin to the side of the unit (Fig. 1).
2. Fix the juice drain cover to the upper part of the body.
3. Apply the rotating sieve to the juice drain cover by pressing on the upper edge of the sieve downwards.
4. Put on the upper lid, and fix it with the locking clip (Fig. 2).
5. Select the required speed according to the processed food using the
speed switch. The higher speed is suitable for food with low juice content
(apples, carrots, etc.). The lower speed is suitable for food with high juice
content (pears, oranges, peaches, etc.).
6. Insert washed pieces of food in the feeder slowly.
You can feed in whole apples and pears, or you may cut them into pieces.
You don't have to peel them or remove the cores. Peel oranges first, feed
in only individual grapes. It is difficult to extract juice from bananas,
avocados, blackberries, figs, strawberries, etc.
NOTE: Always use the stuffer to push food through the stuffing opening.
Never push in food using your fingers, a fork, spoon, knife or any other
object (Fig. 3).
7. Continuously check the volume of pulp in the bin, or stuck to the upper lid.
If the pulp needs to be removed, turn the unit off and wait until the rotating
sieve stops. Close the juice drain upwards. Release the upper lid using the
closing lock, clean it, empty the pulp bin and clean the rotating sieve.
8. After use turn off the product and unplug from the mains outlet.
NOTE: Extracted juice is designed for immediate consumption, as it oxidizesvery
fast in the open air, which can make its taste worse, change its color and, most
importantly, decrease its nutritional value. Apple or pear juice turns brown fast;
you can slow down this process by adding a few drops of lemon juice.
Juice jug with foam separator
During juicing you cannot avoid formation of a foam, so we have redesigned
the juice container and the foam remains in the juice container now.

CLEANING AND MAINTENANCE

Before cleaning the unit, always disconnect the power cord from the wall outlet!
The surface of the unit may only be cleaned using a wet cloth. Do not use any
detergents or hard objects as they may damage the unit's surface!
Wash the removable parts in warm water.
Never clean the unit under running water, do not rinse it, and do not
submerge it in water!
1. Open the closing clip.
2. Open the upper cover.
3. Release the juice drain cover upwards together with the rotating sieve (Fig. 4).
4. Remove and clean the pulp bin.
5. After you finish cleaning the removable parts, follow the reverse steps to
re-assemble the unit.
LO 702x
EN
Fig. 1
Fig. 2
Fig. 3
Fig. 4
29