Operation; Rotary Dial Instructions (Both Rotary Dials Work Together); Control Board - EuroLite LED THA-150F Theater-Spot Bedienungsanleitung

OPERATION

After you connected the device to the mains, the LED THA-150F Theater Spot starts running.
During the reset, the motor is trimmed and then the device is ready for use.
You can choose the desired setting via the buttons MODE, ENTER, UP and DOWN.
The device has two operating modes. It can be operated in stand-alone or in DMX-controlled mode.
Stand-alone mode
In the stand-alone mode, you can do without a controller.
Disconnect the theater spot from the controller.
Rotary dial instructions
(both rotary dials work together):
The Dimmer and Zoom rotary dials are located on the side of the device, as listed under the chapter
Description of the device.
Dimmer-Dial: Press the Dimmer dial and you can adjust the brightness step by step, while at the same time
the Zoom dial enables faster brightness settings. Press the Dimmer dial again and you're back in DMX
mode.
Zoom-Dial: Press the Zoom dial and you can adjust the zoom step by step, while at the same time the
Dimmer dial enables faster zoom settings. Press the Zoom dial again and you're back in DMX mode.

Control Board

The Control Board offers several features: you can set the starting address, program the desired dimming
curve or make a reset.
Press MODE to enter the main menu. Browse through the main menu by pressing Up or Down. Press Enter
in order to select the desired menu. You can change the selection by pressing the UP or DOWN buttons.
Press ENTER in order to confirm your choice. You can leave every mode by pressing MODE. The functions
provided are described in the following sections.
23/32 00120837, Version 1.0