Description Of The Coffee Maker; Safety Warnings; Installation - Fagor CR-312 Gebrauchsanweisung

interior.qxd
Downloaded from www.Manualslib.com
30/1/04 19:53 Página 8
Please read this instruction booklet care-
fully before installing and using the coffee
maker. Only by doing so will you be able
to achieve the best results and the maxi-
mum safety during use.
1. DESCRIPTION OF THE
COFFEE MAKER
The following terminology will be used
throughout the pages that follow.
A Control panel
B Steam knob
C Water tank
D Lid
E Power supply cable
F Steam and hot water delivery tube
G Cappuccino nozzle
H Drip-tray
I Hot water drip spout
L Pressing pad
M Measuring spoon
N Filter holder
O Filter-lock lever
P 1-cup filter
Q 2-cup filter
R "OK" pilot light
S "ON/OFF" illuminated switch
T Steam switch
U Coffee and water delivery switch

2. SAFETY WARNINGS

• This appliance has been built to make
espresso coffee and reheat
beverages; be careful to avoid burns
from spurts of hot water or steam, or
from incorrect use of the coffee
maker.
• Never touch the hot parts of the
coffee maker.
• After removing the packaging, make
sure that the appliance is complete. In
case of doubt, do not use the
appliance and contact professionally
qualified service personnel.
• The packaging elements (plastic bags,
expanded polystyrene, etc.) must be
kept out of children's reach, because
they may be dangerous.
• This appliance is to be utilised for
domestic use only. Any other use is to
be considered improper and therefore
dangerous.
• The manufacturer takes no
responsibility for any damage that
manuals search engine
GB
may derive from incorrect, erroneous or
irrational use.
• Never touch the appliance with wet or
damp hands or feet.
• Never allow the appliance to be used
by children or incapacitated individuals
without proper supervision.
• In case of breakdown or
malfunctioning, turn off the appliance
immediately and do not tamper with it.
For repairs, contact exclusively a
Technical Assistance Centre authorised
by the manufacturer and request the
use of original replacement parts. If this
stipulation is ignored, the safe use of
the appliance may be compromised.
• The power supply cable of this
appliance must never be replaced by
the user, because its replacement
requires the use of special tools.
Should the cable be damaged or need
replacing, contact exclusively a
Technical Assistance Centre authorised
by the manufacturer, in order to avoid
any risk.

3. INSTALLATION

• Place the appliance on a flat work
surface at a distance from taps and
sinks.
• Check that the voltage of the electrical
power mains corresponds to the
voltage indicated on the appliance
information plaque. Connect the
appliance only to a power source with
a minimum delivery of 10 amps and
fitted with a proper grounding
element. The manufacturer will not be
held responsible for any accidents
that may be caused by the lack of a
grounding element for the appliance.
• In the event of incompatibility between
the mains outlet and the plug of the
appliance, have the plug replaced by
qualified personnel. In the event that
the cable is damaged, contact
exclusively a Technical Assistance
Centre authorised by the
manufacturer, because a special tool
is required for its replacement.
• Never install the coffee maker in an
environment that can reach a
temperature of less than or equal to
0°C (if the water inside it should
freeze, the appliance might be
damaged).
9