Pattfield Ergo Tools PE-EAS 7520 Handbuch Seite 314

Warning!
•
Make sure that the chain tension is always correctly adjusted.
•
Only use a chainsaw if it is in perfect working order.
•
Only work with a saw chain that has been properly sharpened in
accordance with the instructions.
•
Never cut with the upper edge or the tip of the cutter rail.
•
Always hold the chainsaw firmly with both hands.
Cutting wood which is under tension
Danger!
Special care is required when cutting wood which is under tension.
Wood which is under tension from which it is released by cutting may
in some cases react completely unpredictably and uncontrollably. In
the worst case this could result in extremely severe or even fatal inju-
ries. This type of work must only be performed by persons who have
been specially trained.
8. Maintenance
8.1 Replacing the saw chain and cutter rail
GB
The cutter rail needs to be replaced if
the guide groove of the cutter rail is worn;
Proceed as described in the section "Assembly of the cutter rail and
the saw chain".
8.2 Checking the automatic chain lubrication
You should check the operation of the automatic chain lubrication
system on a regular basis in order to guard against overheating and
the associated damage to the cutter rail and the saw chain. To do
this, point the tip of the cutter rail towards a smooth surface (board,
section of a cut tree) and allow the chainsaw to run. If an increasing
oil trace becomes evident during this process then the automatic
chain lubrication system is working properly. If no clear oil trace is
evident then please refer to the corresponding instructions in "Troub-
Anl_PE_EAS_7520_SPK7.indb 314 Anl_PE_EAS_7520_SPK7.indb 314
- 314 -
29.07.16 09:40 29.07.16 09:40