Pattfield Ergo Tools PE-EAS 7520 Handbuch Seite 308

working slacken the chain again, as the chain will shorten when it
cools down. This will prevent the chain from being damaged.
5.4 Saw chain lubrication
Warning! Always disconnect the mains plug before performing any
checks or adjustments. Always wear protective gloves when working
on the chainsaw to protect yourself against injury.
Notice! Never operate the chain if it is not lubricated with saw chain
oil. Use of the chainsaw without saw chain oil or if the oil level is
below the "min" mark will damage the chainsaw.
Notice! Be aware of the temperature conditions: diff erent lubricants
with completely diff erent viscosities are required at diff erent ambi-
ent temperatures. At lower temperatures you will need low viscosity
oils in order to achieve a suffi cient lubricating fi lm. However, if the
same low viscosity oil is used during the summer it will become even
thinner due to the ambient temperatures alone, and as a result the
lubricating fi lm could break down, causing the chain to overheat and
become damaged. In addition, the chain oil would burn and produce
GB
unnecessary pollutants.
Filling the oil tank (Fig. 9):
•
Place the chainsaw on a flat surface.
•
Clean the area around the oil tank cover (Item 21) and then open
the oil tank cover.
•
Fill the tank (Item 20) with saw chain oil. In the process, make sure
that no dirt enters the tank, as this could cause the oil nozzle to
become blocked.
•
Close the oil tank cover (Item 21).
Anl_PE_EAS_7520_SPK7.indb 308 Anl_PE_EAS_7520_SPK7.indb 308
- 308 -
29.07.16 09:40 29.07.16 09:40