Operation; Using The Shoulder Strap; Connecting To The Mains Supply - Pattfield Ergo Tools PE-EAS 7520 Handbuch

6. Operation

Please note that the statutory regulations governing noise abatement
may diff er from one location to another.

6.1 Using the shoulder strap

Warning! Always use the shoulder strap when working with the
equipment. Switch off the equipment before you take off the shoulder
strap (Otherwise there is a risk of injury.)
1. Fig. 10: Hook the carabiner (T) into the strap holder (E).
2. Fig. 11: Place the shoulder strap (4) over your shoulder and adjust
the length of the strap so that the strap attachment is at waist le-
vel.
3. Fig. 12: The shoulder strap is equipped with a buckle. Fold the fas-
tener up in the direction of the arrow if you need to put the device
down quickly.
Warning! Never wear the strap diagonally over the shoulder and
chest. Always wear it over the shoulder only, as this allows you to re-
move the device quickly from your body in the event of danger.
6.2 Setting the telescopic tube (Fig. 13)
1. Open (a) the telescopic tube lock (8).
2. Pull out the telescopic tube (9) until it reaches the required wor-
king height.
3. Close (b) the telescopic tube lock (8) again.

6.3 Connecting to the mains supply

•
Connect the power cable to a suitable extension cable. Make sure
that the extension cable is designed for the power rating of the
chainsaw.
•
Secure the extension cable as shown in Fig. 14 to protect it
against pulling forces and accidental disconnection.
Anl_PE_EAS_7520_SPK7.indb 309 Anl_PE_EAS_7520_SPK7.indb 309
- 309 -
GB
29.07.16 09:40 29.07.16 09:40