Before Starting The Equipment; Mounting The Additional Handle - Pattfield Ergo Tools PE-EAS 7520 Handbuch

3. Health damage caused by hand-arm vibrations if the equipment is
used over a prolonged period or is not properly guided and main-
tained.

5. Before starting the equipment

Before you connect the equipment to the mains supply make sure
that the data on the rating plate are identical to the mains data.
Warning!
Always pull the power plug before making adjustments to the
equipment.
Warning! Do not connect the chainsaw to the power supply until it
has been fully assembled and the chain tension has been adjusted.
Always wear protective gloves when working on the chainsaw to pro-
tect yourself against injury.
Carefully unpack all parts and check that they are complete (Fig. 1).

5.1 Mounting the additional handle

(Fig. 2, 2a)
GB
The additional handle consists of the grip (L), counterpart (M) and 4
screws (F).
Push the handle (L) over the grip (Fig. 1/Item 2) and the shoulder
strap attachment (E). Place the counterpart on the fi xed tube (6) abo-
ve the shoulder strap attachment (E) and screw the grip (L) to the
counterpart from underneath using 4 screws (F).
After loosening the 4 screws (F), you should be able to push the
additional handle (Fig. 1/Item 5) on the fi xed tube to suit your requi-
rements. Then tighten the 4 screws (F) again so that the additional
handle (Fig. 1/Item 5) is again attached securely to the fi xed tube (6).
Anl_PE_EAS_7520_SPK7.indb 306 Anl_PE_EAS_7520_SPK7.indb 306
- 306 -
29.07.16 09:40 29.07.16 09:40