On/Off Switch; Switching Off - Pattfield Ergo Tools PE-EAS 7520 Handbuch

•
Connect the extension cable to a professionally installed safety
mains outlet with ground contact. We recommend using a cable
with a bright and highly visible color, e.g. red or yellow. This will re-
duce the risk of accidentally damaging it with the chainsaw.
6.4 On/Off switch
Switching on
•
Hold the chainsaw by the handles with both hands (thumbs under
the additional handle).
•
Press and hold the safety lock-off (Fig. 14/Item R).
•
To switch on the chainsaw, activate the ON/OFF switch (Fig. 14/
Item 3). You can then release the safety lock-off.
Switching off
Release the ON/OFF switch (Fig. 14/Item 3). Always disconnect the
mains plug when you stop working, even if it is only for a short time.
7. Working with the chainsaw
GB
Preparations
To ensure that you can work safely, check the following points before
every use and in the event of any damage:
Condition of the chainsaw
Inspect the chainsaw before the start of work for damage to the
housing, the power cable, the saw chain and the cutter rail. Never use
a chainsaw which is obviously damaged. - Danger of accident!
Danger! The protective devices must not be removed or modifi ed. -
Danger of accident!
Never use the saw if the safety equipment is not working properly.
Never try to repair safety related protection systems yourself – always
have any work done by our service department or by a similarly quali-
Anl_PE_EAS_7520_SPK7.indb 310 Anl_PE_EAS_7520_SPK7.indb 310
- 310 -
29.07.16 09:40 29.07.16 09:40