Automatic Charging Mode - Schumacher Ecobat EBC1 Benutzeranleitung

USING THE QUICK-CONNECT CABLE CONNECTORS
Connect either of the two (2) output cable leads to the charger. Make sure to place the
charger on a dry, non-flammable surface.
Never connect the clip and ring terminal connectors together for
IMPORTANT
use in other applications, such as external battery or other power
source charging, or to extend the output cable length, as reverse polarity and/or
overcharge conditions will occur.
USING THE 50 AMP BATTERY CLAMPS
1. Connect the end of the charger output cable to the end of the battery cable
quick-connect and clamps.
2. Follow the steps in sections 6 and 7, to connect the output clamps to the
battery.
3. Connect the charger to a live grounded 230V AC outlet.
USING THE RING CONNECTORS
1. To permanently attach to a battery, loosen and remove each nut from the bolt
at the battery terminal.
2. Connect the red POSITIVE connector ring to the POSITIVE battery terminal.
3. Connect the black NEGATIVE connector ring to the NEGATIVE battery terminal.
4. Replace and tighten the nuts to secure.
5. Connect the cable to the end of the charger output cord.
Take care to keep the wires and plug away from metal and moving parts.
6. Connect the charger to a live grounded 230V AC outlet.
BATTERY CHARGING TIMES
CCA = Cold Cranking Amps
BATTERY SIZE/RATING
SMALL BATTERIES
Motorcycle, garden tractor, etc.
CARS AND TRUCKS
Times are based on a 50% discharged battery and may change, depending on
age and condition of battery.

AUTOMATIC CHARGING MODE

When an Automatic Charge is performed, the charger switches to the Maintain Mode
automatically after the battery is charged.
Ah = Amp Hour
200-315 CCA
• 11 •
CHARGE TIME (1A)
6-12 Ah
12-32 Ah
36-46 Ah
3¾-7½ h
7½-20 h
18-25 h