Display Options; Resetting To Factory Defaults - Balluff BLA0003 Betriebsanleitung

BLA 50A-002-S4
BLA 50A-002-S4
Balluff Light Array
4
Operation and mode selection (continued)
Blanked areas
Fig. 4-11: Blanking active (left: Value display; right: Blanking setting)
4.6

Display options

Available options are SleepTime, Rotation and Contrast.
The display turns off after the time set under SleepTime.
Either 1 min, 5 min or 15 min can be selected. The factory
default setting is 15 min.
Pressing any key reactivates the display.
The menu item Rotation allow you to rotate the display by
180°.
The menu item Contrast is used for changing the contrast
and display brightness. Possible values: 0...23; factory
default setting: 16
4.7

Resetting to factory defaults

Two options are available, back to settings and RESET
settings.
RESET settings resets the sensor to its factory defaults.
Back to settings or pressing the C key takes you back to
the higher menu level without resetting.
www.balluff.com
Blanked areas
13
english