Connect Peripheral Equipment; Side Connections - Philips 32pw9768 Bedienungsanleitung

Connect Peripheral Equipment

There is a wide range of audio and video equipment that can be connected to your TV.
The following connection diagrams show you how to connect them.
Note: can handle CVBS and RGB,
EXT. 1
It is preferred to connect peripherals with RGB output to
If your recorder is provided with the Easylink function, it should be connected to
functionality.
Recorder
(VCR-DVD+RW)
CABLE
2 2
EXT. EXT. EXT.
1
2
4
Other equipment (satellite receiver, decoder, DVD, games, etc.)
CABLE
1
4
2

Side connections

1 2 3
EXT. 2
Connect the aerial cables 1, 2 and, to obtain the optimum
picture quality, eurocable 3 as shown.
If your recorder does not have a euroconnector, the only possible
connection is via the aerial cable.You will therefore need to tune in
your recorder's test signal and assign it programme number 0 or
store the test signal under a programme number between 90 and
99, see Manual installation, p. 6.
See the handbook of your recorder.
Decoder and Recorder
Connect a eurocable 4 to your decoder and to the special
euroconnector of your recorder. See also the recorder handbook.
See Decoder, p. 9. You can also connect your decoder directly to
EXT. 1
Connect the aerial cables 1, 2 and 3 as shown (only if
&
your peripheral has TV aerial in-/output).
Connect your equipment with a eurocable 4 or 5 to one of
the euroconnectors
quality.
é
Look for the test signal of your peripheral in the same way as
you do for a recorder.
3 5
" Make a selection in the Setup, Source menu, p. 9.
When a recorder is connected to
programme from your TV. Only when a recorder is connected to
EXT. 2
from other connected equipment.
Camera or Camcorder
& Connect your camera or camcorder as shown.
é
Connect to
equipment. For stereo equipment also connect
S-VHS quality with an S-VHS camcorder is obtained by
connecting the S-VHS cables with the
AUDIO
Do not connect cable 1 and 2 at the same time. This may cause
picture distortion !
Headphone
& Insert the plug into the headphone socket L as shown.
Press ¬ on the remote control to switch off the internal
é
loudspeakers of the TV.
The headphone impedance must be between 8 and 4000 Ohm. The
headphone socket has a 3.5 mm jack.
In the Sound menu select
headphone volume.
CVBS, RGB and Y/C,
EXT. 3
or as RGB provides a better picture quality.
EXT. 1 2
or with a eurocable.
2
EXT.1
it is possible to record a programme from your TV as well as
2 and
VIDEO
inputs 3.
and CVBS.
EXT. 4
to benefit from the EasyLink
EXT. 2
, , or to obtain a better picture
2 3 4
you can only record a
EXT. 1
3 for mono
AUDIO L
S-VIDEO
Headphone volume
3.
AUDIO R
input 1 and
to adjust the
23