Connect Peripheral Equipment; Other Equipment; Side Connections - Philips 28PW9520 Bedienungsanleitung

Connect Peripheral Equipment

There is a wide range of audio and video equipment that can be connected to your TV.
The following connection diagrams show you how to connect them.
Depending on the versions, the TV set is equipped with 2 or 3 SCART connectors EXT1, EXT2 and EXT3
located on the rear.
Note: can handle CVBS and RGB,
EXT. 1
peripherals with RGB output to
If your recorder is provided with the Easylink function, it should be connected to
functionality.
Recorder ( -
VCR DVD
CABLE
2
EXT.
1
2
4

Other equipment

CABLE
1
1
2
4
3 5
2

Side connections

1 2 3
CVBS and Y/C,
EXT. 2
or as RGB provides a better picture quality.
EXT. 1 EXT. 3
+ )
RW
Connect the aerial cables 1, 2 and, to obtain the optimum
picture quality, eurocable 3 as shown.
If your recorder does not have a euroconnector, the only
possible connection is via the aerial cable.You will therefore
need to tune in your recorder's test signal and assign it
programme number 0 or store the test signal under a
programme number between 90 and 99, see Manual installation,
p. 6. See the handbook of your recorder.
Decoder and Recorder
Connect a eurocable 4 to your decoder and to the special
euroconnector of your recorder. See also the recorder
handbook. See Decoder, p. 8. You can also connect your
decoder directly to
(satellite receiver, decoder, DVD, games, etc.)
Connect the aerial cables 1, 2 and 3 as shown (only if
&
your peripheral has TV aerial in-/output).
Connect your equipment with a eurocable 4 or 5 to one of
the euroconnectors
quality.
é
Look for the test signal of your peripheral in the same way as
EXT.
you do for a recorder.
" Make a selection in the Setup, Source menu, p. 8.
Camera or Camcorder
&
Connect your camera or camcorder as shown.
é
Connect to
equipment. For stereo equipment also connect
S-VHS quality with an S-VHS camcorder is obtained by
connecting the S-VHS cables with the
AUDIO
Do not connect cable 1 and 2 at the same time. This may cause
picture distortion !
Headphone
Insert the plug into the headphone socket L as shown.
&
Press ¬ on the remote control to switch off the internal
é
loudspeakers of the TV.
The headphone impedance must be between 8 and 4000 Ohm. The
headphone socket has a 3.5 mm jack.
In the Sound menu select
headphone volume.
CVBS and RGB. It is preferred to connect
EXT. 3
EXT. 2
or with a eurocable.
EXT. 1 2
or
EXT.1, 2 3
2 and
VIDEO AUDIO L
inputs 3.
Headphone volume
to benefit from the EasyLink
to obtain a better picture
3 for mono
3.
AUDIO R
input 1 and
S-VIDEO
to adjust the
15